Out Of Stock
Product Code:

USB over Category Cable Extender, Remote

Extends any USB 1.1 or 2.0 device up to 330 ft (100 m) point-to-point over one CAT5e (or better) unshielded twisted pair cable.

JOD 689.00
USB Device Support USB 1.0/1.1 and 2.0 compatible including mass storage and isochronous devices[1]

*Maximum USB Devices 30 USB devices
or 4 USB hubs with 26 USB devices
USB Hub Support Any signal chain may include up to 4 USB hubs plus one USB-EXT-2-LOCAL and one USB-EXT-2-REMOTE[1]
USB Throughput USB 2.0 up to 480 Mbps
USB 1.1 up to 12 Mbps
Remote Extender 24V 1A :(1) 2.1 x 5.5 mm DC power connector;
24 Volt DC power input (power pack included) [3]
Link (1) : 8-pin RJ45 connector
Connects to Link port on the Local Extender [1]
Config (front) : (For factory use only)
USB (front) : (2) USB Type A connectors
USB 2.0 host ports for connection of USB mice/ keyboards/ whiteboards/ game controllers/ cameras/audio devices/ mobile devices/printers/ flash drives/ hard drives/ hubs/ and other USB devices [2];
Available USB Power: 1 Amp maximum per port
1.5 Amps maximum total
Remote Extender Power (1) Blue LED
indicates operating power is supplied via the local power pack or via the Link connection [3]

Link (1) Green LED
indicates a valid Link connection to the Local Extender

Host (1) Green LED
indicates a valid connection to the USB host at the Local Extender

Activity (1) Amber LED
indicates data activity on the Link interface

Mode (rear) (1) Recessed pushbutton (for factory use only)
Connectivity, standard USB extension up to 100 m (330 ft) over solid-core CAT5e (or better) unshielded twisted pair (UTP) cable[2]
General Features
Dimensions Height : 1.03 in (26 mm) without feet
Width : 2.96 in (75 mm)
Depth : 3.43 in (87 mm)
Power Management
Power Available USB
Power Supplies 1 A maximum per each of two USB
Type A ports
1.5 A maximum total
USB‑EXT‑2‑LOCAL USB powered via the USB host interface3
USB‑EXT‑2-REMOTE Input: 100-240 VAC
50/60 Hz;
Output: 1 A @ 24 VDC
After Sales Service
Warranty 1-year limited warranty
Notes* [1]The USB extender is engineered to deliver maximum compatibility with the widest possible range of devices. Crestron does not guarantee that all USB devices or hosts are compatible with the USB extender. Certain USB devices may require additional driver installation if not directly supported by the computer’s operating system.
[2]For the Link connection between the Local and Remote extenders
as a minimum
use high quality
solid core CAT5e (or better) unshielded twisted pair (UTP) cable. If connecting either extender through a wall jack
a stranded patch cord may be used. The maximum aggregate cable length is 330 ft (100 m) between units. The minimum cable length is 6 ft (1.8 m). Do not connect the Link ports to an Ethernet LAN or any other network or device
including the USB‑EXT‑DM‑REMOTE
[3]The power supply must be connected to either the Local or Remote extender
not both. Power is passed to the secondary extender via the Link connection.